Request Portal

Childress

Building Construction Technology

Inquiring about the location of the forklift to empty the trash as it is piling up. Thanks

Done.

McDaniel

Temple

Cosmetology

May you adjust the temperature in the practical class. Its very Hot!

Adjusted.

McIvor

Addison

Dental Assisting

I have 2 lockers (379 and 389) that need a lock to be cut off. Students are no longer attending school.

Done.

McDaniel

Woods

Welding Technology (Main)

AC is on when heater should be on.

Found heat short cycling on air flow restriction. Economizer stuck. Freed gear and operation returned to normal.

Lamont

Temple

Cosmetology

Practical Classroom very hot. Paper towels needed. Cabinets/ carts need to be assembled. Old furniture need to be moved out. Back salon floor stations need to be moved. Washing powder needed.

Assembled roll carts, still waiting for more cabinets to be cleared, moved old massage chair in hallway to be disposed of, need help moving stations on salon floor. Received more washing powder.

Howard

Kerley

Building Construction Technology

Someone had set all the shop heaters above 100 degrees during the break. I readjusted them back to normal levels this morning. I suggest we add some tamper resistance to the controls. The upstairs AC and downstairs heat have been at war back here. It was sauna level this morning.

Leave at one desired temperature and inform students to stop adjusting controls. Tampering controls WILL NOT be installed.

Howard

Miller

Student Services

I am putting in a request for a new gate badge. (S00372711)

We do not have any more Verkada Badges.

Howard

Curry

Administration

Need additional mouse traps in office... I am currently under attack. I have 3 POWs but currently have no additional storage for future insurgents.

Gave 2 traps.

McIvor

Linzy-Torry

Student Services

I am out of parking decals for the students. Do we have anymore?

Ordered. Done.

McIvor Lamont

Hardrick

Dental Laboratory Technology

Please assist with unboxing, placement, and initial setup of a new dental milling machine in the center instructional area of the classroom. The machine has been delivered and requires: Safe unboxing and removal of all packing materials Proper placement in the designated central classroom location Positioning to allow student visibility and instructional access Verification that the machine is stable and ready for vendor setup Online/virtual vendor training is required, however the unit must be fully unboxed and physically set up prior to the training session in order for the training to proceed. No electrical modifications are required beyond standard outlet access. This setup is time-sensitive to support scheduled instructional activities.

Done.

McDaniel

Brown

Practical Nursing

Hello, Can we get a deep cleaning for the classrooms/labs and instructor/coordinator offices? (sweep/mop, wipe down classroom desks/surfaces). Thank you!

Done.

Hervey

Durden

Automotive Technology (Main)

Bolt pedestal grinder to the floor in the shop by the second page door.

Bolted to ground needs a new power cord. Rewired. Probably should install 2 more concrete bolt anchors in machine. 4/10/2026

Howard McIvor